Forum Replies Created

Viewing 1 - 4 of 4 posts

  • TCLTR

    Member
    February 25, 2021 at 8:23 pm

    @Jarda

    Documentation also is very odd. It doesnt state that IN0 and IN1 need 24v.

    I was hoping to use all screw terminals however my encoder only runs on 5v and IN0 and IN1 do not support 5v.

    Can you please update documentation so others dont have the same issues.

    I would recommend you state how the screw terminals are expected to be used since I was struggling for a little bit.

  • TCLTR

    Member
    February 24, 2021 at 2:51 am

    So I tried this with 24v and it seems to work. However I wish this would be more clear in the documentation since it states it will run off of 12 or 24.

    Its kind of a pain I need 24v since my application is only 12v, which means I need to get a converter to step up from 12 to 24 only to trigger my screw terminals.

  • TCLTR

    Member
    February 24, 2021 at 2:47 pm

    I would recommend updating the documentation. I purchased a Maxi Automation expecting to run 12v and I have found that doesnt work.

    I only am running AI0-AI13 as digital highs and INO and IN1 however I found found in order to run the screw terminals you must run 24v. This confused me since the documentation states something else. Can you please list this in documentation it might help others.

  • TCLTR

    Member
    February 24, 2021 at 12:23 pm

    Are you sure it isnt the Green LED shining on to that? When I plug mine in via USB i get 12v and 24v green with a light green on the OVL and RST

Viewing 1 - 4 of 4 posts

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.