Forum Replies Created

Viewing 1 - 2 of 2 posts

  • niellsonn

    Member
    May 12, 2020 at 9:36 am

    Hello,

    I had exactly the same problem so I think this might not be a hardware defect. However, I did not pursue solving this problem any further but managed to find a workaround (not using the analog out pins) for my specific problem. So, if you managed to find a solution, I would be happy to let us know.

    Best regards,

    niellsonn

  • niellsonn

    Member
    April 29, 2020 at 7:41 am

    Hi,

    Thank you for answering. At the time of measuring, the Dim+ (Input of the Power Supply) was connected to AO0 and Dim- to GND. But i am not sure what current goes into Dim+. Is it possible that the load resistance is not high enough ?

    niellsonn

Viewing 1 - 2 of 2 posts

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.