Activity › Forums › Questions & Troubleshooting › Hardware › serial lines › Reply To: serial lines

  • Lukas

    Member
    March 9, 2020 at 12:32 pm

    Hi,

    the Serial sends data also to the pin TX / X1. It is the same UART which is forwarded to the USB. But, be careful – when you connect to TX and RX pins on X1 you can have some troubles during sketch upload then.

    TX2 and RX2 are connected to Serial2. Just use it in the same way like Serial … Serial2.print …

    Best regards,

    Lukas

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.