Activity Forums Questions & Troubleshooting Hardware Output problem (Digital) Reply To: Output problem (Digital)

  • w-mets

    Member
    January 23, 2021 at 6:32 am

    Hi Jarda,

    Thanks for your reply. I just took al look on the new forum, I think it’s really good looking!

    For the output problem I put all outputs from of pin D1 to D11 High. I found 24V on each of them after tightening the screws on the terminal.

    On the 5V side only D3 was not giving 5V output, while the LED is green. Could it be due an overload or something? I tried it on another MAXI where I found 5V on D3, so this one works properly.

    Thanks again, keep up the goor work!