Activity Forums Questions & Troubleshooting Hardware Stuck input terminals on new Controllino Mega

  • Stuck input terminals on new Controllino Mega

     Jarda updated 4 years, 5 months ago 2 Members · 3 Posts
  • shiftee

    Member
    March 24, 2020 at 5:59 pm

    I’m doing a project using two Controllino Megas and have found a problem with the input terminals on one of them.

    When I try to loosen the screw the internal chamber does not open and the screw tries to come up out of the block.

    This happens on inputs 0, 9, 11, 12, 13, 14 & 17.

    Is there a way to get them open or do I need to replace them?

  • shiftee

    Member
    March 26, 2020 at 11:48 pm

    Okay, I rang the Controllino guys today.

    They said to open the terminal a little and press down a bit to try and free the terminals.

    I did this and managed to fix all of them :)

    I had to press them quite a few times (you’re flexing the PCB internally so don’t go crazy) but for each one I got a satisfying pop and the terminal opened.

    Note to the Controllino guys: It would be great if you could squeeze in the modular connectors under the covers, this would also make tightening the terminals much less stressful

  • Jarda

    Member
    April 27, 2020 at 9:33 am

    Hello,

    thank you for your inputs and we are sorry for this complication.

    Bets Regards

    Jarda

Viewing 1 - 3 of 3 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now