Activity › Forums › Questions & Troubleshooting › Hardware › PIN HEADER

  • PIN HEADER

     Jarda updated 4 years, 10 months ago 2 Members · 2 Posts
    Hardware

  • arh

    Member
    December 12, 2019 at 9:15 pm

    I don’t fully understand what is PIN HEADER for ? Can anyone give me any explanation pls?

    I want to connect an incremental encoder that is activated with 5v but the inputs of controllino are 12v and 24v, can I just connect (5v and GND) in the PINHEADER and read it in interrupt zero located on PINHEADER .

  • Jarda

    Member
    January 20, 2020 at 12:52 pm

    Hello,

    pinheader is exactly for your application 😊.

    Yes, you can take power from pinheader and also connect the interrupt on the pinheader. Please only take care about the limitation on the pinheader (maximum output current and serial protection resistances which shall be no problem in your application).

    Regards

    Jarda

Viewing 1 - 2 of 2 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.