Output problem (Digital)

Output problem (Digital)

w-mets updated 4 years, 2 months ago 4 Members · 7 Posts
Hardware
Jarda

Member
January 11, 2021 at 9:54 am

Hello,

is the same Sketch working on other CONTROLLINO MAXI please? It is strange, that LED works but both outputs not.

BR

Jarda
w-mets

Member
January 23, 2021 at 6:32 am

Hi Jarda,

Thanks for your reply. I just took al look on the new forum, I think it’s really good looking!

For the output problem I put all outputs from of pin D1 to D11 High. I found 24V on each of them after tightening the screws on the terminal.

On the 5V side only D3 was not giving 5V output, while the LED is green. Could it be due an overload or something? I tried it on another MAXI where I found 5V on D3, so this one works properly.

Thanks again, keep up the goor work!
mr-controllino

Administrator
January 25, 2021 at 9:58 am

Hi,

And what voltage do you measure on this D3 on X1?

regards
Marco
- w-mets
  
  Member
  January 25, 2021 at 11:49 am
  
  Hi,
  
  On X1 I measure 23 mV on D3
  - Lukas
    
    Member
    February 23, 2021 at 9:28 am
    
    Hi, have you already resolved the issue, please? It seems to me that your device is faulty. Thanks, Lukas
    - w-mets
      
      Member
      February 24, 2021 at 11:01 am
      
      Hi Lukas,
      
      Still teh same problem, but I can work arround it. It is sa bit strange though.
      
      Grtz,
      
      Wouter

Viewing 1 - 3 of 3 replies