Activity › Forums › Questions & Troubleshooting › Software & Firmware › Digital outputs

  • Digital outputs

     Jarda updated 4 years, 11 months ago 2 Members · 2 Posts
    Software & Firmware

  • t0mka

    Member
    May 6, 2019 at 3:02 pm

    Hello,

    I would like to ask about implementation of digital outputs. More specifically, if it is possible to apply external voltage on DO which is switched LOW?.

    In my application it would be 24V AC on the same ground as DC which is powering Controllino.

    Thanks,

    Tomas

  • Jarda

    Member
    May 20, 2019 at 4:04 pm

    Hi Tomas,

    no, it is not possible without the external component. DO is realised by high side switch tied to CONTROLLINO input voltage.

    For AC I would prefer to use relay output, which is also presented on CONTROLLINO ;).

    Best Regards

    Jarda

Viewing 1 - 2 of 2 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.