[w-mets]

Hi Jarda,

Thanks for your reply. I just took al look on the new forum, I think it’s really good looking!

For the output problem I put all outputs from of pin D1 to D11 High. I found 24V on each of them after tightening the screws on the terminal.

On the 5V side only D3 was not giving 5V output, while the LED is green. Could it be due an overload or something? I tried it on another MAXI where I found 5V on D3, so this one works properly.

Thanks again, keep up the goor work!

[w-mets]

Hi Lukas,

I am facing some troubles in running DhcpAdressPrinter, I constantly get back “Ethernet shield was not found. Sorry, can’t run without hardware. :(“

Ethernet seems to be correctly connected in IPv4. As I reccon, I don’t have to fill in any MAC adress in the code, and I am using “Ethernet.init(10);”

Could you help me solve this?

Best regards,

Wouter Mets

[w-mets]

Hi Lukas,

Still teh same problem, but I can work arround it. It is sa bit strange though.

Grtz,

Wouter

[w-mets]

Hi,

On X1 I measure 23 mV on D3

[w-mets]

Hi Marco,

Thanks for your reply!

1) I have two SIM800L’s available for testing, the small red 800L core board and the RoHS SIM800L EVB 2.0. I guess they are both plane boards.

2) I tried different power supplies. I tried some battery stacks and a Meanwell HDR-15-5, 2.4 amps with a 100N capacitor. Both SIM-modules mentioned above are running steady now on the MINI.

3) Which pins on the X2 do you exactly mean for UART communication? I tried pin 16 (TXD2) and 17 (RXD2) and pin 18 and 19 on the MAXI, neither of them were succesfull.

Thanks agian!

Best regards,

W. Mets