Forum Replies Created

Viewing 1 of 1 posts

  • hiffi

    Member
    May 14, 2020 at 1:39 pm

    Sorry for the late response.

    Yes! That was the same problem for my Controllino. The 0 Ohm Resistors were missing. So this wasn’t a technical or software issue, but a manufacturing issue.

    I would suggest to replace the resistors by jumpers. Thats would make switching between voltage and current output easier.

Viewing 1 of 1 posts

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.