Forum Replies Created

Viewing 1 - 2 of 2 posts

  • craano

    Member
    April 28, 2020 at 7:26 am

    OK, thanks.

    Just got a new controllino. Now all works fine and as expected.

    The LEDs indicate if outputs are high/low and the voltmeter measures 12V/0V.

    I Send back the used one. I think it is broken.

    Thank you for your help.

    craano

  • craano

    Member
    April 19, 2020 at 7:11 pm

    Hallo,

    i have only the multimeter switched to voltage measurement connected to the digital output and gnd.

    So a power supply with 12V and 1A should be sufficient? But 0V is being displayed.

    Thanks

    craano

Viewing 1 - 2 of 2 posts

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.