Activity › Forums › Questions & Troubleshooting › Software & Firmware › Analog Output Maxi Automation Error › Reply To: Analog Output Maxi Automation Error
-
Hello, I also had the same problem. I contacted the manufacturer and the issue is not a hardware defect, rather a production error. The outputs were configured for 0-20mA instead of 0-10V. If you follow the website tutorial below, you should find that the 0 ohm resistors are missing. So to change the MAXI outputs to 0-10V simply add a solder bridge where the 0 ohm resistors are supposed to be. This fixed the issue for me.
Website tutorial:
https://www.controllino.biz/knowledge-base/current-outputs-maxi-automation/ Regards,
Ethan