Activity › Forums › Questions & Troubleshooting › Hardware › AnalogOut on Maxi Automation › Reply To: AnalogOut on Maxi Automation

  • niellsonn

    Member
    April 29, 2020 at 7:41 am

    Hi,

    Thank you for answering. At the time of measuring, the Dim+ (Input of the Power Supply) was connected to AO0 and Dim- to GND. But i am not sure what current goes into Dim+. Is it possible that the load resistance is not high enough ?

    niellsonn

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.