Activity › Forums › Questions & Troubleshooting › Hardware › Minimum 12 V Power Supply for Screw Treminals › Reply To: Minimum 12 V Power Supply for Screw Treminals

  • Jarda

    Member
    April 17, 2020 at 12:23 pm

    Hello,

    Do you have a load at outputs or are you connecting only the multimetr switched for current measurement ? ;-)

    Each output D0..D11 has overcurrent protection and can deliver maximum of 2 A. You have to have proper load connected to there. And based on the load you have to select the proper 12 V power supply for CONTROLLINO. If you have some of the loads for example 5 A, than approx. 5,5 A power supply shall be selected.

    Regards

    Jarda

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.