Activity › Forums › Questions & Troubleshooting › Hardware › PWM output › Reply To: PWM output

  • Jarda

    Member
    January 20, 2020 at 12:45 pm

    Hello,

    PWM outputs located at the screw terminals are related to the input voltage. If you need 5V only, you can use signals on the pinheader. Only please take into the account the implemented series resistance located to every pin on the pinheader. So connected capacitance must be low (or use some logic gate).

    Regards

    Jarda

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.