Reply To: Firmware update at Maxi Automation with SD Card

[marcel00]

Hello Lukas,

I used the following code to reset:

Code:

void softwareReset( uint8_t prescaller) {
wdt_disable();
// start watchdog with the provided prescaller
wdt_enable( prescaller);
// wait for the prescaller time to expire
// without sending the reset signal by using
// the wdt_reset() method
while (1) {}
}

This works and flashing starts. The only remaining question is: How can I compile the SD dual bootloader after changing Flashing LED port from PB7 to PL7?