Activity › Forums › Questions & Troubleshooting › Hardware › 2.8″ TFT Screen › Reply To: 2.8″ TFT Screen

  • Lukas

    Member
    July 1, 2019 at 1:20 pm

    Hello zal,

    thank you for the photos. You have really nice screw terminals for the flat cables :)

    Again – I have checked your setup and do not see any obvious reason why it should not work.

    Do you have any idea how fast is the communication with the display?

    Please note that there are some protection serial resistors on the pin header lines which may slow down edges of the very fast signals. Do you have any chance to check it with oscilloscope?

    Even that according the datasheet the display should take max 120 mA, mabybe the 5V at the pinheader is overloaded – please, try to supply it externally – at least as part of the investigation.

    Thanks,

    Lukas

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.