Activity › Forums › Questions & Troubleshooting › Software & Firmware › avrdude: stk500_recv(): programmer is not responding › Reply To: avrdude: stk500_recv(): programmer is not responding

  • Lukas

    Member
    February 12, 2019 at 9:03 am

    Hello,

    the issue with interconnection of the RTC INT and RESET of the CONTROLLINO MINI was solved by a hardware modification in 2016.

    I assume that this is not the root cause of your troubles.

    j.dacosta@cfvi.ch stated that it is still possible to communicate with the sketch – so the device is obviously not in the permanent reset state.

    We have observed similar behaviour too, but up to now it is not clear what is the reason. The most probable explanation is, that once you program a corrupted sketch (corruption happens during the upload) the device is then skipping the bootloader and always jumps directly to the sketch after a reset. Then the avrdude is not talking with the bootloader, but with the sketch.

    Please see our FAQ No.10 here https://github.com/CONTROLLINO-PLC/CONTROLLINO_Library#faq

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.