Activity › Forums › Questions & Troubleshooting › Send Digital Signal › Reply To: Send Digital Signal

  • Lukas

    Member
    November 5, 2021 at 2:32 pm

    Hello,

    the problem is that the CONTROLLINO digital outputs are only high-side switches. So they internally connects 12/24 V (when logical HIGH), but not the ground (when logical LOW). You need to add external pull down resistor between the communication line and the 0V. Recommended value of the resistor is 10 kOhm.

    Good luck!

    Lukas

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.