Activity › Forums › Questions & Troubleshooting › Maxi Automation Screw Terminals Not Working › Reply To: Maxi Automation Screw Terminals Not Working

  • TCLTR

    Member
    February 25, 2021 at 8:23 pm

    @Jarda

    Documentation also is very odd. It doesnt state that IN0 and IN1 need 24v.

    I was hoping to use all screw terminals however my encoder only runs on 5v and IN0 and IN1 do not support 5v.

    Can you please update documentation so others dont have the same issues.

    I would recommend you state how the screw terminals are expected to be used since I was struggling for a little bit.

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.