Activity › Forums › Questions & Troubleshooting › Hardware › Fake digital Input signal › Reply To: Fake digital Input signal

  • Franju

    Member
    January 24, 2021 at 11:06 pm

    Hello,

    What about to try doing contact to the input with a cable connected to 12v, and after connected to 0V, and check if the eratic state of the input is gone ? If so, it would mean, I think, that you need a pullup or pulldown resistor, depending to your project.
    Or maybe a switch connected for exemple NC to 12v and NO to 0V ?

    • This reply was modified 3 years, 8 months ago by  Franju. Reason: orthographe

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.