Activity › Forums › Questions & Troubleshooting › Software & Firmware › Poweron-Reset

  • Poweron-Reset

     altprog updated 5 years, 6 months ago 1 Member · 1 Post
    Software & Firmware

  • altprog

    Member
    April 26, 2019 at 4:44 pm

    Hallo,

    im Instruction-Manual steht, dass nach Anlegen der Betriebsspannung automatisch das geladene Programm gestartet wird. Bei mir funktioniert der Programmiert nur nach dem Hochladen. Sogar der Reset-Knopf hat keine entsprechende Wirkung. Was tun ?

    Gruß

    Altprog

    Gelöst:

    das Programm startet korrekt nur die Übertragung zum seriellen Monitor funktioniert nicht mehr. Es handelt sich um das RFC-Beispielprogramm.

Viewing 1 of 1 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.