Minimum 12 V Power Supply for Screw Treminals

[craano]

Hallo,

I got hands on a used Controllino Maxi. I am not sure if it is working.

Only the pins on top seem to be powered.

I cannot measure current with a multimeter on the screw terminals when switched to high.

How many amperes does the 12 volt transformer have to deliver to supply the screw terminals D0 … D11 ?

Thanks.

craano

[Jarda]

Hello,

Do you have a load at outputs or are you connecting only the multimetr switched for current measurement ?

Each output D0..D11 has overcurrent protection and can deliver maximum of 2 A. You have to have proper load connected to there. And based on the load you have to select the proper 12 V power supply for CONTROLLINO. If you have some of the loads for example 5 A, than approx. 5,5 A power supply shall be selected.

Regards

Jarda

[craano]

Hallo,

i have only the multimeter switched to voltage measurement connected to the digital output and gnd.

So a power supply with 12V and 1A should be sufficient? But 0V is being displayed.

Thanks

craano

[Jarda]

Hello,

yes, power supply 12V/1A shall be fine for this type of tests.

Do you have corresponding LED (D0-D11) on the TOP ON when you activate the output in your software?

Regards

Jaroslav

[craano]

OK, thanks.

Just got a new controllino. Now all works fine and as expected.

The LEDs indicate if outputs are high/low and the voltmeter measures 12V/0V.

I Send back the used one. I think it is broken.

Thank you for your help.

craano

[Jarda]

Hello,

thank you for information and I’m sorry for complication with broken CONTROLLINO.

Enjoy the new one.

BR

Jarda