Activity › Forums › Questions & Troubleshooting › Hardware › CONTROLLINO MINI – 5V and 3V pins current

  • CONTROLLINO MINI – 5V and 3V pins current

     Jarda updated 5 years, 6 months ago 2 Members · 2 Posts
    Hardware

  • andreazanellato

    Member
    May 2, 2019 at 4:40 pm

    Hello..

    Into data sheet I guessed that maximum current for 5V and 3V pins (pin header) are 200mA.

    It is right?

    Is it possible to use a 3V peripherals on pin header interface or TTL hight levels are not compatibles?

    Best regards.

    Andrea

  • Jarda

    Member
    May 6, 2019 at 1:21 pm

    Hello zanellato,

    yes, power pins on pinheader are limited to 200 mA in total, not every pin.

    3V3 peripheral will not work because ATMEGA2560 is powered from 5V and will not work with 3V3 level device even when device is tolerant. In case of input, level for processor will be too low. When you will use device which is 5V tolerant, you can use it only, when the external device has no output to the processor.

    The best way will be to use levelshifter.

    BR

    Jarda

Viewing 1 - 2 of 2 replies

Log in to reply.

Original Post
0 of 0 posts June 2018
Now

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.