Controllino Maxi LCD and Eth

[Nacho]

Hi all. Playin with the controllino Maxi I’ve got an issue: I´ve made a program with client eth connection and I’ve connected an LCD as the web page shows, but in Setup() first I put the LCD commands and print something, then I start the ethernet. Ethernet client works fine but the LCD doesn´t work. In Loop() I print something and I get nothing in the LCD. If in Setup() first starts the ethernet and then the LCD, directly doesn´t works. I think that there is an incompatibility between them or Pins or SPI or I don´t know….

Anybody has had that issue? Any recommendation? Thank you for all.

• This discussion was modified 2 years, 9 months ago by  Nacho.

[Nacho]

Nobody has had that problem?