-
Controllino Compatibility
updated 2 years, 5 months ago
4 Members
·
4
Posts
-
Hello All,
Is it possible that we can use Arduino MKR WAN 1300 with Controllino ? Also, can we use All module in Controllino which are compatible with Arduino ?
I am completely new in this field, I hope you can help me.
Thanks in advance. -
You should be able to make serial data exchanges between the MKR WAN 1300 and the Controllino pin header.
The Controllino Pin Headers allows access to the ATmega328P processor, just like you are using a regular Arduino UNO. Once they are connected, then it seems logical that the MKR WAN 1300 could send commands to Controllino.
I have not tested this and have never used a MKR WAN 1300
-
Hello,
in principle Johnnycatt is right, but be careful with 5V vs. 3,3 V boards compatibility!
CONTROLLINO pinheader is 5V (as e.g. Arduino UNO or MEGA), but MKR is 3,3 V (as Zero, MKR, DUE …)
See the warning here.
Warning: Unlike most Arduino & Genuino boards, the MKR WAN 1300 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.
Log in to reply.