Activity › Forums › Questions & Troubleshooting › Hardware › Using RTC INT › Reply To: Using RTC INT

  • richiestine

    Member
    July 27, 2020 at 5:50 pm

    Hello.. I am trying to interface AT89c51 with DS 1307( a real time clock) which uses I2C Communication protocol. The problem is that Real Time Clock could’nt be triggered(started) after setting up the initial register values.I can read the same Data which i’ve sended to DS 1307 Registers again & again.

    rigid flex pcb design for assembly guidelines

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.