Reply To: Encoder on MINI

[Johnnycatt]

Leo,

I am using the Screw Terminals A0 and A1.

I am NOT using the <controllino.h> library, but just the basic “arduino coding.” I have made a mistake and uploaded my Arduino UNO code I was using for practice, NOT my Controllino Code (I will try to edit the original sketch).

The Controllino code should read:

unsigned long A = A0;

unsigned long B = A1;

NOTE: “unsigned long” is not needed here, but I originally used “int” for all my variables in the sketch and with a 600 pulse-per-revolution enocoder, I ran out of numbers very fast and replaced ALL my “int” with “unsigned long.”

As for the Pull-up resistors, I soldered two 6.8kOhm resistors (in parallel) to the end of a wire. One resistor was put into A0 and the other in A1. The other end of the wire was connected to my 12V supply.

AS for the encoder, Channel A from the encoder is ALSO in Screw Pin A0. Channel B is in Screw Pin A1 with it’s resistor. It is not a pretty solution, but it works perfectly.

• This reply was modified 3 years, 7 months ago by  Johnnycatt.
• This reply was modified 3 years, 7 months ago by  Johnnycatt.
• This reply was modified 3 years, 7 months ago by  Johnnycatt.