Activity › Forums › Questions & Troubleshooting › Hardware › [MAXI Automation] Analog IN and internal 5V supply deviation › Reply To: [MAXI Automation] Analog IN and internal 5V supply deviation

  • Friedl

    Member
    February 25, 2021 at 7:34 pm

    Dear Jarda!

    1) As shown above, the 0-10V inputs are nothing more than 2:1 resistive divider, correct? They are not documented in the manual nor on the pinout diagram.

    2) If we’d switch to the 2.56V reference, we could only measure 0-5.12V (2.56V * 2), right?

    3) Am I missing the secret pin to control the switch for the voltage divider on AI12 and AI13 from ratio 2:1 to ratio 3.90625:1?

    Greetings from Graz
    Friedl

    • This reply was modified 3 years, 10 months ago by  Friedl. Reason: wording
    • This reply was modified 3 years, 10 months ago by  Friedl. Reason: typo

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.