Activity › Forums › Questions & Troubleshooting › Software & Firmware › AnalogInput Reading Problem with Maxi Power automation › Reply To: AnalogInput Reading Problem with Maxi Power automation

  • Lro007

    Member
    January 14, 2021 at 3:28 pm

    Hi Ivan..

    I´m working on a data acquisition application of 0-10 V analog sensors, I was working with the Maxi power automation and with a power supply of 24 V, with no problems..

    In this case, a 12V at an input would produce a Result for analogRead of the input = 402

    But after some data analysis i realized that i needed more resolution, so i decided to switch to a 12V power supply following the provided manual instructions, but as you saw earlier in this post the resolution does not change…

    I need 12V at an input to produce a Result for analogRead of the input = 804 or something like that, in order to better take advantage of the 10 bit conversion of the Analog Input.

Report Content

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.